SECTION 3
DRIVING YOUR MOTOR HOME
3-14
Wiper Functions:
There are four wiper control buttons:
•
Wiper On - HI/LO
•
Wiper Off
•
Wiper Delay
•
Wash/Wipe
NOTE:Many states now have laws that require
headlights to be on during precipitation
conditions. To assure compliance with
this law, the headlights will activate
whenever you press any of the wiper
function buttons - Hi/Lo, Wash or Delay.
You can manually reset the headlights by
cycling the headlight switch (on the
dash) on and off. The headlights will also
turn off when the ignition switch is
turned off.
Wiper On - Hi/Lo
•
Press to turn wipers on at Lo speed
•
Press again to switch wiper speed back and
forth from Lo to Hi speed.
•
Press Off button to switch wipers off.
Wiper Off
•
Press to shut wipers off.
•
Wipers will also switch off when the ignition
is turned off.
Wiper Delay
This switch will set a Lo speed wiper delay time
based on the duration between any two presses
of the button.
Here’s how it works:
•
During a light rain or mist, when your
windshield needs a clearing wipe, press the
button once and the wiper will swipe back and
forth once at Lo speed. Let’s say 7 seconds
later, the windshield needs another wipe -
press the button again and the delay time will
be set to 7 seconds.
•
If the mist gets heavier and you press the
button again 3 seconds after the last wipe, the
delay time will be reset to 3 seconds.
•
The delay time can be set from approximately
1 to 30 seconds.
Wash/Wipe
•
Press switch to activate Lo wipers and spray
washer fluid onto the windshield for as long as
you hold the button.
•
After you release the button, the wipers will
continue for three wipe cycles, then turn off.
•
If wipers are already active, pressing the
switch will simply spray fluid onto the
windshield without affecting wiper setting.
Idle Speed Control
The cruise control system can also be used to
control diesel engine idle speed (rpm) while
parked.
High Idle
•
Shift the transmission into Neutral (N).
•
On the turn signal lever, move the slide switch
to the ON position or press the ON button on
the steering wheel. Accelerate to the desired
rpm. Press and release the SET/COAST or
SET/COAST button on the steering wheel.
WARNING
Do not operate the cruise control on icy or
extremely wet roads, winding roads, in
heavy traffic, or in any other traffic
situation where a constant speed cannot
be maintained.
