![background image](http://html1.mh-extra.com/html/winnebago/horizon-40fd/horizon-40fd_manual_987486051.webp)
4-5
SECTION 4
APPLIANCES & SYSTEMS
For example, if the fluid level is 1-2” below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
For your convenience there is also a tank
monitor panel in the water service center
compartment.
Tank Capacities
See Section 1 - Tank Capacities.
Propane Gas Level
Press and hold the “LP GAS” button to show
approximate propane tank level.
The propane level is registered by a sending
unit on the tank. The gauge mounted on the side
of the tank will give a more accurate indication of
actual tank level if needed.
Water Pump Switch
When you want to use the self-contained
water system, turn on the “Water Pump” switch
on the monitor panel. The “Pump On” light will
illuminate when the pump switch is turned on.
Water will be available as soon as a faucet is
opened.
For your convenience, a switch is also located
in the water center compartment.
Battery Voltage Meter
Press the “House Battery” switch position to
check the level of charge (voltage) in the 12-volt
house batteries.
Press the “Engine Battery” position to check
chassis battery charge.
To get an accurate reading;
1. Both the chassis engine and the generator
engine must be shut off.
2. An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
Water Tank
Water Level
Sensors
Water Center Tank Level Monitor
-typical
Water Center Tank Level Monitor
-typical
Water Pump Switch