4-3
SECTION 4 –
APPLIANCES AND SYSTEMS
Tank Capacities
See “Tank Capacities” in
Section 1 -
Introduction
.
Propane Gas Level
Press the Tank Levels switch to show
approximate propane tank level.
The propane level is registered by a sending
unit on the tank. The gauge mounted on the side
of the tank will give a more accurate indication of
actual tank level if needed.
Battery Charge Meter
Press the Battery Levels switch to check the
level of charge (voltage) in the chassis and house
battery.
This will read the chassis battery voltage. The
house voltage is only showing the Pure
3
Converter output voltage.
NOTE: The house battery will always read
14 volts.
To get an accurate reading:
•
The chassis engine must be shut off and 120-
volt AC shoreline unplugged.
•
An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
Pure
3
DC System (Volta)
See “Pure
3
DC System (Volta)” in
Section 6 -
Electrical
for further information.
Water Pump Switch
Press the Pump switch to activate or
deactivate. Water will be available as soon as a
faucet is opened.
Refer to
Section 7 - Plumbing
for additional
information on the water pump and initial start-
up.
NOTE: Some models may be equipped with a
Water Pump switch in the water service
center on the outside of the motorhome
or within the bathroom area for your
convenience.
Black Waste Level Selector Switch
(Located near monitor panel)
Chassis Battery Levels Switch
Pure
3
State of Charge (SOC) Gauge
(Located on an interior cabinet)
-Typical View
Water Pump Switch