3-5
SECTION 3 –
DRIVING YOUR MOTORHOME
6. When tire pressure testing is complete,
reinstall the valve stem cap (with the cap still
retained in the valve cap tool end).
7. Remove valve cap tool from valve stem cap.
Rear Inner Dual Valve Stem Access
on 18-Hole Steel Wheel with Push-
On Full Wheel Trim or Stylized
Wheels
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” valve cap tool (provided in your
InfoCase).
3. Push the end of the valve cap tool onto the rear
inner dual valve stem cap.
4. Using the valve cap tool as a remote handle,
unscrew the valve stem cap (retaining cap in
the end of the valve cap tool).
NOTE: If the valve stem cap and valve stem
extension unscrew as an assembly, pull
the assembly out of the valve cap tool
end, remove valve stem cap, insert valve
stem extension into valve cap tool, and
reinstall valve stem extension onto valve
stem until snug.
Pull off valve cap tool and re-insert valve
stem cap into end of hose.
5. To check inner dual tire pressure, use the long
handle of the tire gauge to control alignment
and avoid misaligned valve stem deflection.
Inner
rear
dual
Valve
cap tool
18-Hole Steel Wheel with Push-On Full
Wheel Trim
-Typical View
