Wine Guardian 99H0173-20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 30

14
Installation
For questions or help regarding installation, call customer service at 1-315-452-7400 or
email
info@wineguardian.com a sketch of the proposed area where the unit is to be
installed.
Pre-Installation
HUMIDIFIER MAY NOT BE INSTALLED WHERE IT MIGHT BE EXPOSED TO
FREEZING TEMPERATURES. IF THE COOLING UNIT IS MOUNTED OUTSIDE, THE
HUMIDIFIER WILL HAVE TO BE MOUNTED IN THE SUPPLY DUCT TO THE
CELLAR INSIDE THE BUILDING OR MOUNTED AS A FREESTANDING UNIT
INSIDE THE CELLAR.
To check for any possible non-visible shipping damage, you may wish to test the unit
before installing it. To do so, remove the unit from its packaging and set it on any sturdy
level surface. If your humidifier is a freestanding unit, plug in the unit. If the unit is to be
connected to a cooling unit, you need to wire the humidifier to the cooling unit and the
cooling unit must be turned on (Refer to page 14). Set the humidistat above the room
humidity. The unit should now come on. The water solenoid should open, and the fan
should come on. Listen for any unusual noise or vibration. Change the humidistat
’s set
point below the room
’s current condition and the unit should turn off.
NEVER MODIFY THIS EQUIPMENT. CHANGES OR MODIFICATIONS MAY VOID
THE WARRANTY, CAUSE DAMAGE TO THE EQUIPMENT, AND/OR CREATE A
SAFETY HAZARD.
NEVER PLACE ANYTHING ON TOP OF THE UNIT. NEVER BLOCK OR COVER
ANY OF THE OPENINGS OR OUTLETS OF THE UNIT.
NEVER ALLOW ANYTHING TO REST ON OR ROLL OVER THE POWER CORD,
AND NEVER PLACE THE UNIT WHERE THE POWER CORD IS SUBJECT TO
WEAR OR ABUSE.
DO NOT REMOVE OR OPEN ANY ACCESS DOOR OR COVER UNLESS THE UNIT
IS UNPLUGGED.