Wine Guardian 99H0173-20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 30

17
Fig. 9 Fig. 10
Integrated Installation (Sentinel)
Note
: Integrated humidifiers can be mounted on either of the two side openings of the
cooling unit on the cooling/evaporator end only. If a duct connection is in that position,
move the duct connection to the top or other side.
DO NOT MOUNT THE HUMIDIFIER ON THE CONDENSER END OF THE UNIT
1.
Remove Drip Pad from plastic bag and install in unit by lifting up on the spring-
loaded drip tray. (See Fig. 1 on page 14)
Note : The pad must be installed in the correct position. The pad must be installed with
the black
spot “Up”, next to the drip tray. Swing the drip tray and drip pad back to a
vertical position to finish the assembly of the drip pad.
2.
Attach the access panel and rotate (2) captive latches to secure the access panel
to the humidifier housing (See Fig. 9 on this page).
3.
Remove side access panel on the side of the cooling unit where you wish to
mount the humidifier.
4.
Install a ½” (1.27cm) flexible drain line from the bottom of the humidifier to an
open drain or connect into the drain line from the cooling unit. (
5.
Install a ¼” (.635cm) warm water line from the water supply to the connection at
the top of the humidifier (see Fig. 7 on page 14). A shut off valve (not provided) is
recommended to isolate the humidifier from the water system when needed.
6.
Connect the communication cable to the top of the humidifier and to the side of
the Wine Guardian system (see Fig. 8 on page 14). The communication cable
provides power and control signals to the humidifier from the Wine Guardian
main control panel.
7.
Proceed to set-up of Remote Interface Controller within the wine cellar to re-
program for humidity control