CONTROLS
FLX3 980087 04/01/03
3-8
3. ONE TOUCH SWITCH
This switch controls the scrub brushes and vacuum all in one touch. To start scrubbing, press the one touch
switch. The brush drive motors will turn on, the scrub deck will lower to the “light scrub” position, the solution will
flow at “two bars” rate, the squeegee will lower and the vacuum will turn on. The information display window will
show which functions are operating. If the direction control pedal is in the neutral position for more than two
seconds the brushes and solution flow will stop. If the one touch switch is activated without brushes installed, the
brush motors will stop, the scrub deck will rise, and the brush pressure indicator will display error code 9000. To
stop scrubbing, press the one touch switch. The brush drive motors will turn off, the scrub deck will raise the
solution flow will stop, the squeegee will raise after a 15 second delay, and the vacuum motor will turn off. This
delay is to clear the vacuum hose of recovered solution.
4. BRUSH PRESSURE SWITCH
This switch controls the amount of brush pressure to the floor. There are 5 different pressure settings. To
decrease the amount of down pressure, press the top of the brush pressure switch (-). To increase the
amount of down pressure, press the bottom of the brush pressure switch (+). The information display screen
will show the amount of pressure.
NOTE:
Press switch and hold momentarily each time to change brush pressure.
INFORMATION DISPLAY
LESS PRESSURE
MORE PRESSURE
INFORMATION DISPLAY
