Part #110895F AGSBDT Rev 01 - 06 .22 .11
3301 East Deseret Drive, St . George, UT 84790
For additional Technical Support visit www .WilsonElectronics .com
or email at: tech@wilsonelectronics .com
Phone: 866-294-1660 Local: 435-673-5021 Fax: 435-656-2432
www .twitter .com/WilsonCellular www .facebook .com/WilsonCellular
Signal Booster Specifications
SIGnalBooST™ DT Specifications
Model number
271265
Outside antenna connectors
F-Female / SMA-Female
Outside antenna impedance
75 / 50 Ohms
Inside antenna connectors
SMA
Inside antenna impedance
50 Ohms
Dimensions
6 .5 x 4 .5 x 1 .75 inch (16 .5 x 11 .4 x 4 .4 cm)
Weight
0 .47 lbs (0 .213 kg)
Frequency
824-894 MHz / 1850-1990 MHz
1
Passband Gain (nominal)
800 MHz
55 dB
1900 MHz
60 dB
2
20 dB Bandwidth (nominal)
Downlink
800 MHz
45 MHz
1900 MHz
88 MHz
Power output
800 MHz
1900 MHz
Power output for single cell phone (uplink)
30 .8 dBm
30 .5 dBm
Power output for single received channel (downlink)
26 .0 dBm
25 .2 dBm
4
Power output for multiple transmitted channels (uplink)
Maximum Power
The maximum power is reduced
by the number of channels:
number of channels
800 MHz
1900 MHz
2
24 dBm
21 .3 dBm
3
20 .5 dBm
17 .8 dBm
4
18 .0 dBm
15 .3 dBm
5
16 .1 dBm
13 .3 dBm
6
14 .5 dBm
11 .8 dBm
4
Power output for multiple received channels (downlink)
Maximum Power
The maximum power is reduced
by the number of channels:
number of channels
800 MHz
1900 MHz
2
24 .8 dBm
23 .7 dBm
3
21 .3 dBm
20 .2 dBm
4
18 .8 dBm
17 .7 dBm
5
16 .8 dBm
15 .7 dBm
6
15 .3 dBm
14 .2 dBm
noise Figure (typical)
3 .5 dB nominal / 6 dB nominal
Isolation (uplink/downlink)
> 90 dB
Power Requirements
110-240 V AC, 50-60 Hz, 8 W
notes:
1 . nominal gain is the maximum gain at any frequency in the passband .
2 . nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB lower than the passband
amplification . One of the frequencies is lower than the passband and the other is higher .
3 . The Manufacturer’s rated output power of this equipment is for single carrier operation . For situations when multiple carrier signals are present, the rating
would have to be reduced by 3 .5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users . This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device .
4 . The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled .
