Wildlife Acoustics sm3bat, Руководство пользователя

Страница: 24 / 86

SM3BAT Setup SM3BAT User Guide
page
18
BIOACOUSTIC MONITORING SYSTEMS
1. Turn the four thumb-screws

counterclockwise to remove the memory bay
cover. You may need to clear any debris, sand, or dirt that may have
accumulated along the sealed edges.
2. Refer to the embossed letters A, B, C, and D on the cover to identify each card
slot (also shown below).
3. To remove a card, lightly push it forward and then feel it release from the slot
and pull it out.
4. To insert a card, lightly push it forward until each card is secure. Insert at least
one card and up to three additional cards.
5. Turn the four thumb-screws

clockwise to tighten and re-apply the cover.
TIP: Insert multiple SD memory cards to take advantage of failover capabilities.
If an error occurs on one card, the SM3BAT can continue writing data on another card.
If the recorder is unable to write to all available SD cards, on of the following
errors appear:
2016-Jan-31 09:00:00
CARDS FULL, ERROR, or DIRTY
0: 24000 ---
-------
1: 24000 --- -------
A card marked "DIRTY" indicates that a critical write operation affecting the file
system (typically at the very beginning or ending of a recording) was interrupted
due to an unrecoverable error or power failure. The Song Meter SM3 will avoid
further use of a "DIRTY" card to avoid further card corruption that could lead to
unrecoverable data loss. "ERROR" indicates some other flash card problems The
"DIRTY" condition can be cleared by accessing (writing) the card on your host
computer or by reformatting the card using the SM3 on-board formatting utility.