Wiedenmann Terra Spike SL 6, Перевод оригинальной инструкции по эксплуатации

Страница: 41 / 63

All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
41
8.0. Service
8.2. Maintenance and inspection list
Working
hours
Check Procedure
1 after initial
use
the position of the tines to each other
the position of the tines to each other
is set with the buffers.
6
after initial
use
Tines are firmly mounted Check
Bolts and screws are firmly secured Tighten screws if necessary
Rubber-metal rails Visual inspection
Rubber buffer or counter plate has
built-up dirt Clean
Drive belt Check the tension of the belts and
tighten (see Chapter 8.9.)
All linings See Chapter "Safety"
Every
8
Bearings and gearbox to ensure that
they are leaktight Visual inspection
rubber-metal rail and buffers for
damage and cracks Visual inspection
Built-up dirt inside Clean
Manual lubrication point,
see Chapter 8.3.1.
Every
40
The gears, couplings, universal-joint
shaft etc. Check for noises
Drive shaft lubrication status See separate operator`s manual from
the drive shaft manufacturer
Cleanliness of tines Cleaning
Drive belt Check the tension of the belts and
tighten (see Chapter 8.9.)
Guides for cleanliness and lubrication
Visual inspection
Buffer for the upper link adjustment
Bolts and screws are firmly secured
Bearing bushings for rear roller and
their holders Inspect for wear, if there is more than
0.08 in. of clearance the bearing
bushes must be replaced
Stop bumper Check status, change if defective
rubber-metal rail and buffers for
damage and cracks check condition; if defective, replace;
if necessary, check more often
the position of the tines to each other adjust the position of the tines using
the buffers; if necessary, adjust more
often
Every
100
Replace all rubber-metal rails and
buffers. set the position of the tines to each
other