All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
45
8.0. Service
8.6. Checking or replacing rubber parts
4.
Remove hex screws (A) and place
the swing lever (B) down.
To remove the defective metal rail
(C), the hex bolts on the back (D)
must be loosened.
NOTE:
For the installation, we recommend
replacing the Nord-Lock locking
washers.
To install the metal rail (C), the
hex bolts (A and D) must be
tightened to a torque of
120 Nm (88.5 lbf ft)
.
5.
To remove the defective rubber
buffers (E), the countersunk
screw (F) must be loosened.
6.
When installing the buffers
(E), the countersunk screws
must be firmly tightened.
7.
To readjust the buffers (E),
the locknut (G) must be
loosened.
8.
At the threaded end of the
buffer holder, a size SW10 (H)
wrench is applied to adjust the
buffers.
9.
When adjusting the buffers, the
tine position relative to the
other tines must be taken into
account.
10.
To fix the adjustment in place,
firmly tighten the locknut (G).
11.
Swing the swing lever (B)
upwards and fasten it to
the metal rail (C) with the
hex bolts (A).
