Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 7152 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
++49 7152 9939 - 40
website: www.widos.de
email: [email protected]
14.08.15
Working Instructions WIDOS 16000 mobile
Page 33 of 63
7. Maintenance, care and repair
Goal of the chapter is:
•
Keeping the nominal state and the operation capacity of the machine.
•
Increasing the efficiency by avoiding non-planned outage.
•
Efficient planning of the maintenance work and the maintenance tools.
7.1. Maintenance and inspection, repair
All maintenance and repair work have to be basically performed with the
machine in off position.
During this the machine has to be secured against unauthorized switching on.
Prescribed maintenance and inspection work should be performed in time.
The DVS gives the advice of inspection work after 1 year.
For machines with a especially high usage percentage the testing cycle should
be shortened.
The work should be performed at the WIDOS GmbH company or by an
authorized partner.
•
The operators are to be informed prior to the maintenance and repair work.
•
Do control all screwed connections if being tight.
•
After completion of the maintenance work, check all security devices on their functionality.
Especially check strength of isolation resp. puncture and resistor of protection line.
7.2. Storage
•
The cylindrical waves of the basic machine are to be kept free from dirtiness and need to
be covered with a thin oil film if they are not being used.
•
Store the machine dry.
7.3. How to clean the machine
The used materials and tissues are to be handled and disposed of properly, especially:
•
when cleaning with solvents,
•
when lubricating with oil and grease.
