Kunststoffschweißtechnik
Maintenance, care and repair
Chapter 7
14.08.15
Working Instructions WIDOS 16000 mobile
Page 35 of 63
7.6. How to check and refill the hydraulic oil
The oil filler neck and the red screw including the oil dipstick are located on the rear side of
the machine, between switch cabinet and pump, within the base frame.
•
Check the oil level of the hydraulic unit before
every start-up of the control unit in order to
avoid damages.
•
Detach the red cap (with integrated oil
dipstick) from the hydraulic tank.
•
Wipe the oil dipstick by a lint-free cloth and
put it back again.
•
Pull the oil dipstick out again and check the oil
level by means of the two markings (the oil
level should be between these two markings).
•
In case the oil level is below the lower marking, you must refill hydraulic oil of the quality
HLPD 32; detach the black cap for this purpose.
•
The oil level must not be above the upper marking since otherwise there is the danger of
overflowing in certain circumstances.
•
Tighten both caps again after having completed the procedure.
7.7. Used hydraulic oil
Only use
HLPD 32
.
Features: protection against corrosion, resistance to ageing, abrasion-
reducing additives, high carrying capacity and particularly water
repelling.
The hydraulic oil has to be disposed of
properly
.
7.8. Pipe cutter
The cutting blades are very sharp!
Make sure during any work at the cutter that you do not cut yourself at the
blades!
The blades are located at the end of the cutter beam.
•
Replace the blades as soon as the cutting quality decreases.
•
You may also reverse the blades, they are usable on four sides:
Knifes = cutting plates: SCFT090404FN using countersunk screws
SS1111 M3,5 x 8 and Torx screwdriver T15.
Oil filler neck
Oil dipstick
