CLEANING ((continued)
PAINTED AREAS - These can be cleaned using a dry cloth.
STAINLESS SSTEEL A
AREAS - These areas may be cleaned using a soft damp cloth or stainless steel cleaner.
IMPORTANT - Always clean in the direction of the grain, and never across it as this will scratch the surface. It is
recommended that a small inconspicuous area is attempted before cleaning the entire stainless steel area - to
ensure the cleaning material is suitable.
LOGS A
AND CERAMICS - Carefully remove the ceramic components. Gently clean in the open air. Be careful not
to create dust from the logs or pebbles. Where necessary replace damaged components with genuine spares.
Seal scrap components in plastic bags and dispose of at proper refuse sites as directed.
Re-fit the logs carefully by referring to the relevant section of these instructions.
GLASS C
CRYSTALS - If necessary, the glass crystals may be removed from the firebowl and cleaned in lukewarm
mild soapy water. Rinse thoroughly in clean water and ensure the glass in completely dry before refilling.
Important - W
Wear pprotective ggloves w
when hhandling tthe gglass ccrystals.
LIST OF SPARES
PA
ART N
NO.
ITEM
CE/F550060
Pack of 8 large ceramic logs (Log Version Only)
CE/F550061
Pack of 6 small ceramic logs (Log Version Only)
CE/F780019
Ceramic log support (Log Version Only)
CE/F780037
Bag of vermiculite (Log Version Only)
CE/F550071
Pack of 10 individual Ceramic Pebbles (Glass/pebble models only)
CE/F920006
Pack of heat resistant Glass Crystals (Glass/pebble models only)
FR/005480-0 3 piece Marble frame
FT/F730015
Control valve
FT/F730006
ODS pilot unit
FT/F730016
Injector
FT/F870009
Control knob
9.0
