WhisperGen PPS16 Installation and Commissioning Manual Rev: 080801
Installation Checklist
2
Before you install the WhisperGen
Read and understand the PPS16 User’s
manual.
Attend the WhisperGen installation course.
Read, understand, and comply with the
relevant
local authority regulations
which
apply to this installation.
Read, understand and comply with the
Recreational Craft Directive 94/25/EC
,
issued by the Council of the European
Community.
Read the Enable Starts warning.
Page Task
Details
Complete
(
)
Unpacking and mounting the WhisperGen
1
The WhisperGen is unpacked. All parts and
the installation pack are complete, and on
site.
1
The WhisperGen is mounted in a position
which is:
•
clean and dry; and
•
with sufficient ventilation.
1
The WhisperGen is securely bolted in
position.
4
The WhisperGen is pressurised with nitrogen
gas to 22 – 24 bar cold, (25°C).
Plumbing the coolant circuits
5
The exhaust heat exchanger is fitted, and
bolted to the burner.
6
The primary coolant circuit is plumbed using
tubing which:
•
has an inside diameter of between
19mm and 30mm;
•
is rated for continuous operation at 1.5
bar at 100°C;
•
has as few bends as possible; and
•
has no sharp bends or kinks.
9
The primary coolant pump is mounted directly
below the coolant tank.
9
For series circuits, a self-bleeding header tank
is installed at the highest point in the circuit,
and the primary coolant circuit is self-bleeding
of air.
