Wheatstone Corporation E1, Техническое руководство, Страница: 19 / 92

page 2 – 3
E-1 / Apr 2010
I N P U T P A N E L
Press the fader’s A/B switch and hold it until the button lights (as opposed to
tapping it for source switching). This switches the VGA screen to the Input tab for
this fader, where you can change the programmed sources for A and B, select the
fader mode, adjust panning, and set up VDip. All of these functions are covered
in the following paragraphs, with the exception of VDip, which is discussed in
the next chapter on the master panel.
You can deselect the selected fader by pressing and holding the A/B button until
the light goes out. You can also select a fader from the VGA screen by clicking
on the CHANNEL STATUS button of the fader you want to select, or deselect an
already selected fader by clicking on its CHANNEL STATUS button.
Once lit, the A/B button stays lit until you light A/B on a different fader, or
deselect the fader, or until a timeout of approximately 20 seconds occurs. This
timeout is optional, and can be defeated in the options text file, which is discussed
in the appendix.
Input Tab Display
When you press and hold an Input fader’s A/B button the Tab display switches
to the Input Tab for that channel. You can click on various buttons to configure
the channel for your application. Note that the Source window is interactive.
A Button Bar located near the bottom of the Input Tab provides for navigation
between the SOURCE, EQ, DYNAMICS, VDIP, and Preset LOAD-SAVE screens.
A typical Input Tab SOURCE screen is shown below, followed by descrip-
tions for each of the functions. Other screens from the Input Tab are discussed at
the end of Chapter 3.
Function Tabs
Currently selected fader strip
Function Pane
Button Bar
NOTE:
When A/B is pressed
and held, the FUNCTION
PANE displays the last
feature selected from the
Input Tab’s “Button Bar”—
Source - EQ - Dynamics
- VDIP - Load - Save
E-1 / Nov 2012