7
Westward Operating Instructions and Parts Manual 1KEN3, 1KEN4
10”,12” Drill Presses
NOTE:
Table removed from bracket in illustration for
clarity.
Figure 3
3. Place the rack (5) inside the table bracket (3), making
sure the worm gear (1) on the inside of the table bracket is
engaged with the teeth of the rack and the arrow stamped
on the rack is pointing up.
Figure 4
4. Slide the table assembly with the rack onto the column.
5. Engage the bottom of the rack (5) with the lip of the column
support (6). Tighten the table bracket lock handle (4) to lock
the table assembly to the column.
Figure 5
6. Install the rack ring (7) on the column so the top lip of the
rack sits into the rack ring.
IIMPORTANT:
The bottom of the collar MUST NOT be pushed
all the way down onto the top of the rack. MAKE SURE the top
of the rack is under the bottom of the collar and that there is
enough clearance to allow the rack to freely rotate around the
column. Tighten the set screw (8).
NOTE:
To avoid column or collar damage, DO NOT
OVERTIGHTEN the set screw.
Figure 6
4
3
5
6
8
7
5
1
3
2
4
5
3
1
