6
Westward Operating Instructions and Parts Manual 1KEN3, 1KEN4
10”,12” Drill Presses
Assembly
For your own safety, never connect
plug to power source outlet until all assembly steps are
complete and you have read and understood the safety
and operating instructions.
ON / OFF switch (Figure 1)
The ON / OFF switch has a removable, safety switch
key. With the key removed from the switch, unauthorized
and hazardous use by children and others are minimized
as the switch can not be turned on without the key.
1. To turn the drill press “ON”, insert key (2) into the slot of
the switch (1). Move the switch upward to the “ON”
position.
2. To turn the drill press “OFF”, move the switch downward.
3. To lock the switch in the OFF position, grasp the sides of
the safety switch key, and pull it out.
4. With the switch key removed, the switch will not turn the
power tool on.
5. If the switch key is removed while the drill press is running,
it can be turned “OFF” but cannot be restarted without
inserting the switch key.
ALWAYS lock the switch “OFF” when
the drill press is not in use by removing the safety switch
key keep it in a safe place. In the event of a power failure,
blown fuse, or tripped circuit breaker, turn the switch
“OFF” and remove the key, preventing an accidental
startup when power comes on.
Figure 1
The drill press is a heavy power tool
and should be lifted with the help of two people OR MORE
to safely assemble it.
Assembling column to base (Figure 2)
1. Position the base (2) on a fl at worksurface.
2. Place the column (1) on the base, aligning the mounting
holes to the base.
3. Locate the hex bolts (3) from the loose parts bag.
4. Place a bolt in each hole through the column support and
thread into the base. Tighten with a 12 mm wrench.
Figure 2
Installing table to column assembly (Figures 3 through 7)
1. Insert the worm gear (1) into the table crank handle
hole (2) from inside the table support (3). Make sure the
worm gear (1) meshes with the inside raising/lowing gear.
2. Install the table bracket lock handle (4) into the hole at the
rear of the table bracket assembly.
NOTE:
Install the handle from left to right, so it enters the
non-threaded side of the table bracket fi rst as shown
in Figure 4.
WARNING
For your own safety, never connect
For your own safety, never connect
For your own safety, never connect
For your own safety, never connect
!
For your own safety, never connect
WARNING
!
3
1
2
WARNING
!
1
2
