9
Westward Operating Instructions and Parts Manual 1KEN3, 1KEN4
10”,12” Drill Presses
3. Open the jaws of the chuck (1) by rotating the chuck
sleeve clockwise. To prevent damage, make sure the jaws
are completely receded into the chuck.
Figure 11
4. Unlock the table support lock (4- Figure 5) and swing the
table away from the bottom of the chuck.
5. Using a rubber mallet or a hammer and a block of wood,
tap the chuck onto the spindle fi rmly (Figure 12).
Figure 12
Mounting drill press to work surface (Figure 13)
1. If mounting the drill press to a workbench, a solid wood
bench is preferred over a plywood board, to reduce noise
and vibration.
2. Holes should be pre-drilled through the supporting surface.
3. The hardware to mount this drill press is NOT supplied
with the tool. The hardware as shown in the illustration
should be used:
Figure 13
1. Drill press base
2. Bolt
3. Flat washer
4. Rubber washer
5. Worksurface
6. Flatwasher
7. Lockwasher
8. Hex nut
9. Jam nut
1
5
2
3
4
6
7
9
8
2
1
3
