8
Westward Operating Instructions and Parts Manual 1KEN3, 1KEN4
10”,12” Drill Presses
7. Install the table crank handle (9) onto the worm gear
shaft (11) on the side of the table support (12).
8. Line up the fl at side of the shaft with the set screw (10)
in the crank handle and tighten the screw with the 3mm hex
wrench provided.
Figure 7
Installing the head (Figure 8)
The Drill Press head is heavy and
TT
should be lifted with the help of two people OR MORE to
safely assemble the drill press head on the column.
1. Carefully lift the head (1) and slide it into the column (2).
Make sure the head slides down over the column as far as
possible. Align the head with the base.
2. Using the 4mm hex wrench provided, tighten the two
head locking set screws (3) on the right side of the head.
Figure 8
Installing feed handles (Figure 9)
1. Thread each feed handle (1) into the threaded holes (2) on
the hub assembly (3) and Tighten.
Figure 9
Installing the chuck (Figures 10, 11, 12 )
1. Clean out the tapered hole in the chuck (1) with a clean
cloth and a non-alcohol based cleaner. Wipe clean all oil
reside and any dirt or grime thoroughly.
2. Clean tapered surfaces on the spindle (2) in the same
manner as above.
NOTE:
Make sure there are no foreign particles sticking
to the surfaces. The slightest piece of dirt or oil reside on
any of these surfaces will prevent the chuck from seating
properly. This will cause the drill chuck and bit to wobble.
Figure 10
1
2
3
2
1
10
9
11
12
1
2
3
WARNING
!
