20
EASY 6000
– Issue 02
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI)
– tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: [email protected]
E
N
G
L
I
S
H
Command 46 Setting the safety temperature:
This command is for setting the temperature the safety device trips at, namely the temperature above which
the vending machine goes out of service while the display will show a warning message. This control is
inhibited when turned on and after closing the door for the time set by command 45. The preset value is 8°C
but it can vary from 8°C to 25°C. This temperature must be higher than that at which the compressor comes
on. To reset the fridge safety device: with the door open, the vending machine display shows that the device
has tripped. Resetting is carried out by pressing the ENTER key on the keypad. If you press ESC or close the
door, the intervention remains on and is recorded as ERROR 93. If the fridge safety device is still on when
the door is closed again, an acoustic alarm will sound automatically (a series of beeps).
The products must be introduced at the correct temperature for preservation as specified
by the regulations in force. The non-observance of this regulation could activate the
“refrigeration safety device".
For detailed des
criptions on the reloading modes, see paragraph “GUIDELINES FOR
LOADING
PRODUCTS”
8.2.3
TO SET MACHINE PARAMETERS
Command 50 Setting the delivery door speed and drum operation parameters:
Using this command it is possible to change the operating speed of the delivery doors in the final section of
their stroke. The value is expressed as a percentage of the maximum speed and can vary from 40 to 95
(40% ÷ 95% of the maximum operating speed). The preset value is 60%.
Below it is possible to carry out the drum positioning tests, selecting the number of the desired drum on the
request of the VMC and then of the various stopping positions; with each stop, the data relating to positioning
will appear on the display (absolute position expressed in encoder pulses and number of compartments).
Command 51 Setting the refilling mode:
The refilling mode you wish to use can be set using this command. The following options are available:
0 FAST refilling:
this function enables the machine as if it had been completely refilled. It is carried out by
opening the door and closing it again.
1 NORMAL refilling
by drum: when you enter the corresponding number of the drum (1 = first drum at the
top) in the keypad (see fig. page 15), you cause a rotation of about 1/3 of a turn. The operation must be
carried out with the door open. See paragraph 9 REFILLING / SALE OF PRODUCTS.
2 SMART refilling:
in this case, the presence of the product and the sell-by date are checked during the
sale. The filling operation is carried out with the door closed through the delivery doors, See paragraph 9
REFILLING / SALE OF PRODUCTS.
When you use fast or normal filling, and therefore with the door open, you obtain
access to moving parts.
Command 52 Setting the refilling safety device:
This command enables or disables the safety device during SMART refilling of the vending machine. If the
safety device is enabled (parameter set at 1), the door of a compartment being filled will close before the
column rotates towards the next empty compartment and will then reopen.
If the value is set at 0 on the other hand, the delivery door will stay open until all the compartments that are
open or contain expired products are filled or replaced.
This parameter is set at 1 by default.
Command 54 Setting the delivery door opening time:
This commands makes it possible to set the time the delivery door stays open for. The preset value is 10
secs. but it can vary from 1 to 60 secs.
Содержание Easy 6000
Страница 1: ......
