24
Assembly | Operation
Hints for the used Grinding Disc
To avoid injuries always use suitable grinding discs that are in proper
condition!
With the simple sound test you can check the disc for cracks and
damages. Hang up the grinding disc so it can swing freely (e. g. on a thick
thread) und knock the disc edge with an object. The disc should give a
clear and high pitch sound. If the sound is damped or blank, the grinding
disc is defective and should not be used further more.
Make sure before carrying out any work on the saw chain sharpener that
the plug is disconnected from power mains.
Changing the Grinding Disc
1. Switch off the machine and pull
the power plug!
2. Remove the protective cover (D).
Unscrew the 3 retaining nuts with
the included wrench.
3. Hold the grinding disc firmly with
one hand and loosen the nut with
the socket wrench.
4. Replace the grinding disc by a
new one and tighten the nut but do
not overtighten it.
Only use grinding disc with an outer diameter of 145 mm and with an
inner diameter of 22.2 mm. The grinding speed from replacement
discs must meet or exceed the rpm rating of the machine.
6. Mount the protective cover (D) on
the machine.
Changing the Illuminant
1. Switch off the machine and pull the
power plug! Always allow the illumi-
nant to cool down before replacing.
2. Prior to replacing the illuminant,
remove the protective cover (D).
Screws
Nut
Illuminant
