User Guide
6. Management
6.4 Chassis Replacement Procedure
a.
If the drive carrier handle is not in the open state, press the release button to unlatch the
drive carrier from the enclosure. The carrier's handle should extend out.
b.
Align the drive assembly such that the release button is facing up and the handle is facing
away from the enclosure, and slide the drive assembly into the empty drive bay.
c.
Press against the drive (not the handle) until it will not go in any further.
d.
Lift the drive assembly handle in toward the enclosure until it locks in place. This will
secure the drive to the enclosure.
Step 14 :
Complete the previous step for each drive assembly, making sure that the drive is inserted in the
correct slot according to the labels that were added earlier.
Step 15 :
Install the HD Mini-SAS cables into the rear of the ESM.
a.
Read the label on each cable to ensure it is being installed in the correct port.
b.
To insert the connector into the port, orient the cable so that the blue release tab is
facing the ground and insert the connector into the port until it locks.
c.
Complete these steps for each cable until all are installed.
d.
When there is power running to the platform, the activity LED at the back of the ESM will
turn on and remain solid if there is no IO to the drives. This will ensure that it is installed
correctly.
Step 16 :
Insert the power cables into the rear of the PSU.
a.
Plug the power cable into the receptacle at the back of the PSU.
a.
Loop the retention clip around the cable and pinch it until the clip catches and locks in
place.
41