User Guide
6. Management
6.3 Drive Assembly Replacement Procedure
Figure 19:
Drive Carrier Fault LED
b.
To remove the drive assembly, press the release button to unlatch the drive carrier from
the enclosure. The carrier's handle should extend out of the enclosure.
c.
Grasp the handle and pull the drive out with even pressure.
Step 2 :
Install the drive assembly.
a.
If the drive carrier handle is not in the open state, press the release button to unlatch the
drive carrier from the enclosure. The carrier's handle should extend out.
b.
Align the drive assembly such that the release button is facing up and the handle is facing
away from the enclosure, and slide the drive assembly into the empty drive bay.
c.
Press against the drive (not the handle) until it will not go in any further.
d.
Lift the drive assembly handle in toward the enclosure until it locks in place. This will
secure the drive to the enclosure.
37
