7
3
2
86
87
1
63
83
70
70
91
105
83
3. While another person holds the Upright (2) near
the Frame (1), connect the Upper Wire Harness
(86) to the Lower Wire Harness (87).
Tip: Avoid pinching the Wire Harnesses (86,
87).
Insert the Upright (2) into the Frame (1).
Next, slide an M10 Split Washer (70) and a
Frame Spacer (83) onto each of the two M10 x
88mm Button Screws (63).
Insert the M10 x 88mm Button Screws (63) into
the Frame (1) and the Upright (2).
Make sure
that the concave sides of the Frame Spacers
(83) are facing the Frame. Do not tighten the
Button Screws yet.
Attach the Water Bottle Holder (105) to the
Upright (2) with two M4 x 22mm Screws (91).
Avoid pinching the Wire
Harnesses (86, 87)
4. Identify the Left Pulse Bar (107), which is
marked with a “Left” sticker.
Have another person hold the Left Pulse Bar
(107) near the left side of the Upright (2).
Make
sure that the hexagonal holes are in the
indicated location.
See the inset drawing.
Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the left Pulse Wire (113). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: Avoid pinching the wires.
Slide the Left
Pulse Bar (107) onto the Upright (2). Attach the
Left Pulse Bar with two M8 x 38mm Button
Bolts (112) and two M8 Locknuts (46).
Make
sure that the Locknuts are in the hexagonal
holes.
Repeat this step for the Right Pulse Bar
(108).
107
46
2
108
112
113
113
Hexagonal
Holes
4
Avoid pinching
the wires
86
Wire Ties
Wire Tie
113
