Control Panel - User Manual
4 - Control and display elements
Doc.no.: UM-22031
Revision: D
Page 13 of 30
4. Control and display elements
EMERGENCY STOP button
The axis drives can be shut down in emergencies with this pushbutton. All
movements are stopped immediately and the power supply for the servo drives is
cut off. This applies even when an automatic CNC program is run-ning.
NOTE !
Do not use the EMERGENCY STOP button for routinely switching off the axis
drives!
Resetting the EMERGENCY STOP:
Remedy the problem which lead to the button being pressed.
Release the EMERGENCY STOP button.
Switch on the power supply for the servo drives (Servo-ON key).
If necessary, acknowledge fault messages in the software.
The control panel is now ready for operation again.
Joystick
The functioning of the joystick depends on which operating mode is switched on:
With axial control You can traverse a previously activated axis with the
joystick.
With mouse function You can move the mouse pointer on the screen with the
joystick.
Speed control
When the axial control is switched on, moving speed of the machine-axis can be
varied (0-100%).
Changing the alignment and Alignment display
The LEDs shows the orientation of the control panel with respect to the 3
coordinate measuring machine (also refer to Fig. 4.2).
With this pushbutton, you can change the alignment of the control panel with
respect to the 3 coordinate measuring machine independently of the operator’s
workstation. Each time the button is pressed, the alignment is shifted by 90° in the
clockwise direction (also see Chap. 4.4).
Active key
With this key you can switch the axial control on and off. When the axial control is
switched on (the LED Joy shines), you can activate and deacti-vate individual axes
with the aid of the activation keys ("X", "Y", "Z" or "C").