9.4
RS232 Pinout (9-pin D-Sub
DE-9 plug pin-out (9-pin., male),
available at DTE
DTE - data terminal equipment (Terminals
DCE - data circuit-terminating equipment (
Signal
Abbreviation
Name
RxD
Receive
Data
TxD
Transmit
Data
GND
Ground
Application Example:
If the setting is C3---2, C4---27 (default setting), the codes shown in VB as following:
MSComm1.Settings = "600,n,8,1"
MSComm1.Output = Chr(&H1B) + C
’or
MSComm1.Output = Chr(27) + Chr(112)
’or
MSComm1.Output =Chr(27) +"p"
Do DoEvents
Loop Until MSComm1.InBufferCount = 14
a = MSComm1.Input
Print a
10
Configuration &Explain
The settings of the balance can be changed in the
adjusted to individual weighing requirements.
way that normally no more changes must be made, only at special conditi
Overview:
In the off state press the [
CAL
] button and keep it pressed, press the [
balance. Now the balance is accessed to the setting menu. Using the [
menu items (C1-C4) can be selected on
setting value. After all points have been configured,
automatically into weighing mode.
14
Sub)
., male), as it is usually
available at DTE
DE-9 socket pin-out (9-
usually available at DCE
pment (Terminalsresp. computer)
terminating equipment (Balance)
Pin
Typical purpose
DE-
9
DTE (e.g.
PC)
Carries data from
DCE to DTE.
2
Input
Carries data from
DTE to DCE.
3
Output
5
-
27 (default setting), the codes shown in VB as following:
MSComm1.Settings = "600,n,8,1"
MSComm1.Output = Chr(&H1B) + Chr(&H70)
’sent a print commando
MSComm1.Output = Chr(27) + Chr(112)
MSComm1.Output =Chr(27) +"p"
MSComm1.InBufferCount = 14
xplain of the function setting
he settings of the balance can be changed in the setting menu. This way, the balance can be
dividual weighing requirements. By the factory the user menu has been set in a
way that normally no more changes must be made, only at special conditions of use.
] button and keep it pressed, press the [ ] button turn on the
balance. Now the balance is accessed to the setting menu. Using the [
CAL
] button the individual
e selected one after the other. Press the [
TARE
] butt
setting value. After all points have been configured, press [
CAL
] button returns
weighing mode.
-pin., female), as it is
usually available at DCE
Origin
DTE (e.g.
DCE (e.g.
Balance)
Output
Output
Input
-
27 (default setting), the codes shown in VB as following:
’sent a print commando
menu. This way, the balance can be
By the factory the user menu has been set in a
ons of use.
] button turn on the
] button the individual
] button to change the
] button returns the balance
