Wen GN9500X, Инструкция по эксплуатации

Страница: 24 / 44

USING YOUR GENERATOR
CAUTION! Become familiar with the functions and capacity of each component on the control panel before
connecting electrical devices. Do not overload generator or individual panel receptacles. Do not connect 50Hz or
3-phase loads to the generator.
Follow the steps below to properly connect your device(s) to the generator:
1. Before connecting electrical devices, allow the generator to run for a few minutes to stabilize the speed and volt-
age output.
2. Select the device with the highest wattage, and make sure it is turned off. Plug the device into the matching gen-
erator outlet and then turn the device on. Allow the engine to stabilize.
3. Repeat step 2 to plug in each additional device. Do not attempt to plug in or start multiple devices at the same
time.
CONNECTING ELECTRICAL DEVICES
IN CASE OF OVERLOAD
If your generator becomes overloaded from too much drawn wattage, the push-to-reset circuit breaker(s) on your
control panel will activate and cut off the output. When an overload occurs, reduce the load by turning off and
unplugging your electronic device(s), then press the activated circuit breaker to reset your generator. If the circuit
breaker does not reset, wait several minutes and try again. If no power is produced after resetting, restart your
generator.
24
Key
Start
Pairing
Light
12V DC
Outlet
Circuit
Breakers
Data
Meter
NEMA L14-30R
Outlet
Grounding
Nut
Main
Breakers
NEMA TT-30R
Outlet
NEMA 5-20V
Duplex Outlets
Circuit
Breaker
Remote
Power
Remote
Pairing
CO
Sensor