Wen 65911, Руководство пользователя, Страница: 16 / 36

PREPARATION
INSTALLING NEW SANDPAPER (FIG. 10-13)
1. Roll the sanding drum until the slot on the left of the drum
is on top. Reach under the left lip of the drum to locate the
spring clamp.
NOTE: Align the directional arrows printed on the bottom of
sandpaper with the drum’s rotation direction.
2. Lift the clamping device and insert the end of the
replacement sandpaper into the slot (Fig. 10). Push the
sandpaper so that about 1 inch of sandpaper is loaded to
ensure enough grip. Align the left side of the sandpaper with
the left lip on the drum.
3. Release the left clamping device to hold the sandpaper
in place. Pull on the sandpaper to make sure the end of the
sandpaper strip has been securely clamped. If the strip comes
loose, repeat steps 1 and 2.
4. Use your right hand to roll the drum away from you and use
your left hand to apply reasonable tension on the sandpaper
while wrapping the sandpaper onto the drum (Fig. 11). Make
sure that the sandpaper strip remains tight as you wrap it.
IMPORTANT: DO NOT overlap the sandpaper. The sandpaper
should be flush or slightly gapped in between.
5. Once the drum is completely wrapped (Fig. 12), keep
tension on the sandpaper and insert the remaining end of the
strip into the slot on the right of the drum.
6. Press the clamp forward until the slot on the clamp is in line
with the slot on the drum. Insert the end of the sandpaper into
the slot and through the jaw of the clamp (Fig. 13).
NOTE: It may help to insert a holding pin through the hole on
the sanding drum and the clamp to hold the clamp in place as
you are inserting the sandpaper. Remove pin after sandpaper
installation afterwards.
7. Release the clamp to secure the end of the sandpaper.
Check that the sandpaper is properly installed and is wrapped
tight against the drum.
8. Close the drum cover and replace the washer and cap screw.
WARNING: Make sure that the
sandpaper is correctly installed
and tightened onto the sanding
drum before connecting the
machine to the power supply.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
16