12
2.5.8. Setting the countdown timer
This system can operate with a built-in
COUNTDOWN
timer when the transmitter is in the
ON
or
THERMO
mode (
THERMO
or
ON
must be displayed on the LCD-screen).
When the set time period has elapsed, the device will automatically switch off.
DOWN
-
+
UP
SET
RETURN
FAN
BACK
TIME
TIMER
MODE
FLAME
PROGRAM
REVIEW
AHEAD
1. Press
TIME/TIMER
on the transmitter for more
than 5 seconds. The word
TIMER
and 0:15 flash
on the LCD-screen.
2. Press
UP/DOWN
to begin advancing through
each of the countdown time options. Available
countdown times are 15 min/30 min/45 min/1
hr/1hr30/2 hr/2hr30/… up to 9hrs.
3. To set the
TIMER
press
SET/RETURN
. If the
system is ON, it will remain on until the ”timer
time” has expired. If the system is in the
THERMO
mode, it will cycle
ON
and
OFF
as the
room temperature requires
4. To cancel the
TIMER
operation, press the
TIME/TIMER
button for more than 5 seconds
until the ‘timer time‘ disappears.
NOTE:
When the timer is used in THERMO mode, the THERMO operation will discontinue only when the countdown time’
has expired.
2.5.9. Low battery indicator
The word
LOW
outlined by a battery on the left side of the LCD-screen will appear
when battery power has dropped significantly. At this time, approximately two weeks of
battery power remains until the transmitter may experience partial or complete loss of
functions.
Here’s how to replace the batteries:
1. Push the
MODE
-button until OFF appears on the screen;
2. Remove the batteries one by one;
3. Place new batteries, minding their polarity.
Replacing the batteries in an operational mode (ON – THERMO – PROGRAM) can damage the microprocessor.
2.5.10. Place of the remote control system
As the transmitter is also the thermostat of your appliance, it is preferable to locate the bracket on an inside wall, sufficiently
far away from direct sources of heat such as a fireplace, incandescent lighting or sunlight, in order for it to detect actual
ambient room temperatures, and not a single heat source. Before fixing the bracket to the wall, check if the transmitter is not
outside the operating range of the receiver! Normal operating range is ± 6 m, but can vary.
The system operates on RF-signals. The place of the antenna (black thread on the side of the receiver) determines the
operating range of the system. In order to get the system to function as good as it may, the antenna must be free in the
appliance.
Be careful: Transmitter and receiver must be placed at at least 1 meter from electromagnetic fields (such as TV,
radio, PC, microwave oven,…). Repeated exposure to magnetic fields reduces the operating capacity of the
appliances.
Содержание RC-16B
Страница 14: ...14...
