The Weir Group PLC
Weir Industrial Gateway setup guide rev 0.5
Copyright © Weir Minerals Australia Ltd 2017. Commercial in Confidence. All rights reserved.
Page
45
of
46
WLAN Antenna
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 12 dB. Antennas not included in this list or having a gain greater than 12
dB are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
o
Mobile Mark OD6-2400-BLK antenna, 6dBi
o
Mobile Mark SCR12-2400-WHT high gain antenna, 12dBi
16.4.115.4.1
FCC Requirements for Operation in the United States:
This product does not contain any user serviceable components and is to be used with
approved antennas only. Any product changes or modifications will invalidate all applicable
regulatory certifications and approvals.
16.4.215.4.2
FCC RF Radiation Exposure:
The radio has been evaluated under FCC Bulletin OET 65C (01-01) and found to be
compliant to the requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4)
addressing RF Exposure from radio frequency devices. This model meets the applicable
government requirements for exposure to radio frequency waves.
This equipment complies with the FCC RF radiation exposure limits set forth for an
uncontrolled environment. The antennas used for this transmitter must be installed to
provide a separation distance of at least 20 centimetres from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
To comply with FCC RF exposure compliance requirements, a separation distance of at least
33.9 centimetres must be maintained between the user and antenna when the product is
used with the SCR12-2400-WHT high gain antenna.
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
16.4.315.4.3
Industry Canada Requirements for Radio Operation in Canada:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
