The Weir Group PLC
Weir Industrial Gateway setup guide rev 0.5
Copyright © Weir Minerals Australia Ltd 2017. Commercial in Confidence. All rights reserved.
Page
39
of
46
Figure 13-6 Tri-Block
14.5.413.5.4
Removal
1. Release cap screw or retaining bolt and remove sensor from mounting point
2. If required to disconnect sensor from cable :
a. Unwrap protective tape
b. Remove connector
c. Install plastic bung/cap on both sensor and cable connectors
14.613.6
Temperature RTD’s
14.6.113.6.1
Equipment and materials required
• Minimum recommended PPE : gloves, eye protection, hard hat, long sleeves and
trousers
• Allen key. 3/16”
• Small Philips screwdriver
• ¼” UNF x 1” long cap screw and washer x qty 4
• RTD leads (part # SD014-3M) x qty 4
Figure (left): RTD ring at end of 3m lead
Figure (right): RTD fastened to magnetic mount
Figure 13-7 RTD
