Weidmuller SpeedMarking-Laser, Руководство пользователя

Страница: 24 / 36

Troubleshooting
24 5658600000/00/05.07
6.3.1 Congestion in the input area
1 Turn the SpeedMarking-Laser off.
2 Open the cover and remove the toner cartridge.
CAUTION
To avoid any damages, the toner cartridge
should be exposed to the sunlight only for
a few minutes.
3 Remove the accumulated material from the input
area. To do this you may have to move the green
transport belt. Care must be taken to avoid mov-
ing the belt out of its guides.
4 Check whether the input area is completely
cleaned.
5 Insert the toner cartridge again.
6 Insert the alignment rod for the roller in its desig-
nated holding fixture.
7 Close the cover.
8 Turn the SpeedMarking-Laser on again.
The SpeedMarking-Laser should now be operational
again.
If the error LED does not go out, there is
the possibility of accumulated material in
the SpeedMarking-Laser.
6.3.2 Congestion in toner area
1 Turn off the SpeedMarking-Laser.
2 Open the cover and remove the toner cartridge.
CAUTION
To avoid any damages, the toner cartridge
should only be exposed to the sunlight for
a few minutes.
3 Remove the accumulated material from the input
area. To do this you may have to move the green
transport belt. Care must be taken to avoid mov-
ing the belt out of its guides.
4 Check whether the toner area is completely
cleaned.
5 Check whether the Corona unit runs smoothly.
6 Insert the toner cartridge again.
7 Insert the alignment rod for the roller in its desig-
nated holding fixture.
8 Close the cover.
9 Turn the SpeedMarking-Laser on again.
The SpeedMarking-Laser should now be operational
again.
If the error LED does not go out, there is
the possibility of accumulated material in
the SpeedMarking-Laser.