Weco Cruiser 402 T, Инструкция по эксплуатации

Страница: 5 / 50

Cruiser 402 T - Cruiser 502 T
Power Pulse 402 T - Power Pulse 502 T
Cod.006.0001.1680
24/04/2014 v2.0
ENGLISH
5/50
2 INSTALLATION
DANGER!
Lifting and positioning
Read the warnings highlighted by the following symbols in the
“General prescriptions for use”.
2.1 CONNECTIONS TO THE ELECTRICAL MAINS
NETWORK
The characteristics of the mains power supply to which the equipment
shall be connected are given in the section entitled “Technical data”
on page 28.
The machine can be connected to motorgenerators provided their
voltage is stabilised.
Connect/disconnect the various devices with the machine switched
off.
2.2 FRONT PANEL
1. Connector for gas feed hose:
power source J torch
2. Connector for logic signals of TIG torch.
3. Remote controller connector.
4. TIG TORCH welding socket.
5. Negative pole welding socket.
6. Positive pole welding socket.
7. Welding power source ON/OFF switch.
8. Mains protection ON LED.
This LED illuminates if an incorrect operating condition occurs:
- absence of a phase in the power supply line.
2.3 REAR PANEL
1. Power supply transformer fuse.
Type: Delayed acting (T)
Amperage: 2 A
Voltage: 500 V a.c.
2. Signals connector for automatic application.
3. Pre-heating unit power supply socket.
The socket is internally protected by a self-resetting fuse.
Power socket type: Schuko
Maximum power: 130 W
Voltage: 230 V a.c.
4. Connector for gas feed hose:
cylinder J power source
5. Cooler power feeding connector.
Voltage: 400 V a.c.
Current output: 1.0 A
IP protection rating: IP20 (cap open) / IP66 (cap closed)
DANGER!
High voltage!
If the socket is not connected to any devices always close the cap:
presence of hazardous voltage levels!
7
1 2 4 3 5 6
8
9
1 2 3 4
5 7 8 6