Weco Cruiser 402 T, Инструкция по эксплуатации

Страница: 15 / 50

Cruiser 402 T - Cruiser 502 T
Power Pulse 402 T - Power Pulse 502 T
Cod.006.0001.1680
24/04/2014 v2.0
ENGLISH
15/50
FINAL CURRENT
The value of this parameter can be set as a percentage of the welding current or as an absolute value expressed in Amperes.
HF CURRENT
This parameter establishes the current value during HF discharge. The value of this parameter can be set as an absolute value or in SYN.
With SYN setting the HF current value is calculated automatically on the basis of the preset welding current value.
Consequences of a higher value:
- Arc striking is facilitated, even on very dirty workpieces.
- Risk of piercing excessively thin gauge workpieces.
TYPE OF PULSED CURRENT
SLo.
= This setting enables slow pulsed mode.
FA. = This setting enables fast pulsed mode.
PILOT ARC
The function enables the output of a low current between the 1st and 2nd times of the torch trigger to shield the mask in advance and avoid the
risk of blinding flashback caused by the welding current.
CONTACT COMMAND EXPANSION
The function enables the emission of the ARC-ON and ALARM signals via the signals connector for automatic application (See § 7.4 page 46).