Weco Cruiser 402 T, Инструкция по эксплуатации

Страница: 25 / 50

Cruiser 402 T - Cruiser 502 T
Power Pulse 402 T - Power Pulse 502 T
Cod.006.0001.1680
24/04/2014 v2.0
ENGLISH
25/50
Tab. 7 - Parameters of the 1st level menu: SYNERGIC DC TIG mode
ACRONYM PARAMETER MIN DEFAULT MAX
Pr.G. PRE-GAS TIME 0.0 s *7 10.0 s
St.C. STARTING CURRENT
5 A *7 500 A *4
2 % *7 200 % *4
Sl.u. SLOPE UP 0.0 s *7 25.0 s
-
WELDING CURRENT
MAXIMUM CURRENT WITH REMOTE CONTROLLER
5 A *7 500 A *5
S.Cu. SECOND CURRENT B-LEVEL 10 % *7 200 % *1
b.Cu. BASE CURRENT 1 % *6 *7 200 %
PE.t. PEAK TIME 1 % *6 *7 99 %
P.Fr. PULSED CURRENT FREQUENCY 0.1 Hz *6 *7 2.5 kHz
Sl.d. DOWN SLOPE 0.0 s *7 25.0 s
F.Cu. FINAL CURRENT
5 A *7 500 A *4
5 % *7 80 % *4
Po.G. POST GAS TIME 0.0 s *7 25.0 s
*1: This parameter is set as a percentage referred to the value of the following parameter:
WELDING CURRENT
*4: The value of this parameter can be set as a percentage of the welding current or as an absolute value expressed in Amperes.
*5: This setting is used to adjust both parameters.
*6: This value can be displayed but it is not user-adjustable.
*7: The optimal value of this parameter is set automatically by the microprocessor on the basis of the preset welding current value.
*8: The parameter is displayed but it is not used the during welding process when the following setting is present:
MULTI TACK = ON