Weco Cruiser 402 T, Инструкция по эксплуатации

Страница: 20 / 50

Cod.006.0001.1680
24/04/2014 v2.0
ENGLISH
Cruiser 402 T - Cruiser 502 T
Power Pulse 402 T - Power Pulse 502 T
20/50
4.2 SELECTION OF THE WELDING MODE AND TORCH TRIGGER PROCEDURE
Specific torch trigger procedures are available in accordance with the selecting welding mode.
The availability of certain procedures depends on whether or not certain parameters or functions of the unit are enabled or set in the associated
menus.
The table shows the settings to be made to enable each procedure.
KEY
2T: 2 STROKE LIFT-ARC
2T HF: 2 STROKE WITH HIGH FREQUENCY ARC STRIKE (HF)
4T: 4 STROKE LIFT-ARC
4T HF: 4 STROKE WITH HIGH FREQUENCY ARC STRIKE (HF)
4T B-L: 4 STROKE B-LEVEL
4T B-L HF: 4 STROKE B-LEVEL WITH HIGH FREQUENCY ARC STRIKE (HF)
2T Q-SPOT: 2 STROKE TACKING
2T Q-SPOT HF: 2 STROKE TACKING WITH HIGH FREQUENCY ARC STRIKE (HF)
9 :
Always available.
1:
Available with the following setting: HF= on
S6 Use this button to select one of the following welding modes.
S5 Use this button to select one of the following torch trigger procedures.
PROCEDURE
+
+ + +
MODE 2T 2T HF 4T 4T HF 4T B-L 4T B-L HF 2T Q-SPOT 2T Q-SPOT HF
MMA
DESEAMING MODE
9 1 9 1 9 1 9 1
TIG DC CONTINUOUS
9
1
9
1
9
1
9
1
PULSED DC TIG
9 1 9 1 9 1 9 1
SYNERGIC PULSED DC TIG