WebEye WE-VTP-1-0101-MYWEBEYE BASIC, Руководство пользователя, Страница: 6 / 25

10
11
Storage temperature:
-40 … +85°C
SIM card: 2,85 V
GSM Aerial
Aerial: LambdaCom Internal aerial
Operating frequency: 800-1900 MHz
Output power:
-102..-108 dBm
GPS Aerial
Aerial: SR Passives ANT1590-1840H
Operating frequency: 1575…1610 MHz
Dimensions
Inclusive size of the box: 99x77x30 mm
Size of the circuit card: 80x606x24 mm
NECESSARY PRECAUTIONS
WARNING!
Do not disassemble the device. If the device, the cable or the connector is
damaged, do not connect them to the vehicle.
Every wireless data transmitting device causes interference, which may also
affect other devices located in the vicinity.
Only a trained technician (automotive electronics technician) is allowed to
connect the vehicle tracking device to the vehicle.
Fasten the device strongly to the specified place.
Keep the device away from intensive heat, water and vapour, electrostatic
charges and electric discharges.
Safety requirements
This chapter contains information on the safe operation of the MyWebEye device. By following
these requirements and recommendations you can avoid dangerous situations. Please read the
instructions carefully and follow them before bringing the device into operation.
The unit uses a 9-32V power supply unit. Its nominal voltage is 12 V DC voltage. The permitted
voltage range is 9-32V DC voltage.
In order to avoid mechanical damage, you should store or transport the device in its packaging
until it is installed. Before final installation and use you should place the device in such a manner
that the control LEDs on the device should be highly visible to the person installing it, by which you
can verify the functioning of the device (successful installation).
When the device is installed, the vehicle must not be under ignition.
Before removal pull the cable connector off the device.
All connected devices need to comply with the requirements of the MSZ EN 60950-1 standard.
Proper use
Detaching tool Overcurrent protection
appliance
HD SUB24 connector 4.0A Fuse
INSTALLATION GUIDE
Pin diagram of the MyWebEye unit
Red Power supply (+30)
Black Earth cable (31)
Blue Ignition (+15)
White/blue striping CAN Low
White/grey striping CAN High
Important! Do not mix up the CAN L and the CAN H connectors.
Do not mix up the power supply cables.
Connect the power supply cables at the end of installation.
Do not cut the cables. If cutting still becomes necessary, cut only one cable at
a time.