INSTALLATION AND COMMISSIONING | 41
7.2
Checking
Inspect the cutter devices for damage. If the cutting device is not in pristine condition, it must
not be used! In this case, immediately contact your supplier.
• Check the blades (damage)
• Check the control handle including pushbutton (function)
• Check the couplings (damage, dirt)
• Check the hand grip (securely fastened)
• Check the protective cover (damage)
• Check the hoses (damage)
7.3
Installation
Move both control levers on the hydraulic power unit to the „0“ position (Fig. 1), pull
off the dust protection cover on the coupling and connect the hydraulic hoses with the cutter as
described in chapter 4.4. In order to avoid contamination then re-couple the protective caps.
When using the SINGLE coupling, coupling can also be carried out without pressure („0“
position on power unit not necessary).
When operating a hydraulic power unit observe the operating instructions for the equipment!
Fig. 1
