POSSIBLE APPLICATIONS | 37
5.7
Continuous Cuts (C 100-31)
Continuous Cuts are possible with the C 100-31 without the need for time-consuming V-cuts.
Here the special cutting device is set at right angles to the object to be cut (drive in from
above) and the cutter driven closed.
It is necessary to ensure that the cut-out piece falls from the ejection aperture. Then open
the cutter again and re-insert it into the same cut. It is possible to continue to work vertically
downwards in this way.
5.8
Pressing (combi tool with RZM)
In order to further increase the spreading path of the combi tools, it is optionally possible to
fit a mechanical rescue cylinder to these two devices. These are inserted in the shear blades
with spring-loaded bolts (see page 29, „4.6 Changing the spreader tips“). In order to ease
insertion of the RZM, the blades should be slightly opened!
If the shear blades of the combi tool are now driven apart, the RZM also opens up to a final
length.
ATTENTION!
Whilst pressing with the RZM, the combi tool moves towards the vehicle.
Therefore avoid standing in the direct working area of the combi tool!
