OVERVIEW
Webasto BlueCool Classic Series
10
3.2.2
Digital Display Panel
All Webasto air conditioning units are controlled by a Digital Display <AIR CONTROL> which gives
access to all functions necessary for the normal operation of the unit and attached accessories
(blowers, pumps, etc.).
In order to start the system you only need to press the
key on the digital display. From there on the
electronic control unit takes care of the progressive starting up of the air conditioning unit as well as
its normal functioning.
The digital display will show the present air temperature of the cabin in which the digital display is
situated or where the main temperature sensor is located (in case it is placed in a different room).
After a delay of approx. 20 seconds the display will indicate the cycle in which operation the unit will
start i.e. <COOL> or <HEAT>. The choice will depend upon the setpoint temperature and the air
temperature as measured by the external air temperature sensor.
After a further delay of approx. 50 seconds the compressor(s) will start up and the normal operation
cycle will begin.
Figure 3
Digital Display
1
2
3
4
5
6
7
8
9
Cool
Auto
Heat
1 Temperature or Function Readout
2 Set Point Modification Key
-
Press to read setpoint temperature
-
Hold to raise setpoint temperature.
3 Set Point Modification Key
-
Press to read setpoint temperature
-
Hold to lower setpoint temperature.
4 Dedicated Blower Speed Key
5 Set-Up / Programming Key
-
Allows access to secondary functions and
programming
6 On/Off Key
-
Press to turn on
-
Press again to turn off.
7 Led indicating system working in heat mode
8 Led indicating automatic cycle-switching is
active
9 Led indicating system working in cool mode
