Automatic sauna splash system, Sauna Plus 8
Index: 05 Change date: 11.09.2018
Operating instructions no.: BA DW 003-05 Sauna Plus 8 EN 24+230V.docx
Page 62 of 76
Components of the hose dosing pump
Figure 20, Hose dosing pump spare parts
Exchanging the pump hose
Gently pull the hose holder forwards at the suction and pressure connection and
remove the transparent pump cover and the lock washer in order to exchange the
pump hose. Turn the roller carrier to the left and pull the dosing hose forwards
through the recess in the roller carrier. (also see Figures in
Section 5.2
)
Pull the hose holder with the dosing hose out of the guide and carefully remove
the cable ties at the hose connections with a sharp knife or with pliers while taking
care that the hose nipple is not damaged. Push the new dosing hose onto the hose
nipples up to the limit stop, so that the markers at the hose ends are in front. This
ensures that the hose is not twisted. Fasten the hose ends with the hose binders
and cut off protruding parts of the hose binders. Turn the roller carriers
anticlockwise and carefully press the hose into the housing (see Figures in
Section
5.2).
Click back the lock washer and the pump cover.
Clean the heater shower
The heater shower will necessarily calcify after some period of use. Clean the auto-
matic sauna splash system by switching it off, unscrewing the shower, cleaning it
mechanically and with mild acid and re-attaching it hand-tight. Only use Teflon tape
for sealing.
The hose pump
Type
Sa
31 Pump cover
32 Lock washer
33 Hose set (hose holder with hose)
34 Roller carrier
35 Pump housing
36 Sealing disk, felt
37 Sealing disk, EPDM
38 Geared motor
39 Installation screws
