Automatic sauna splash system, Sauna Plus 8
Index: 05 Change date: 11.09.2018
Operating instructions no.: BA DW 003-05 Sauna Plus 8 EN 24+230V.docx
Page 37 of 76
appropriate parameters. The cycle mode selected will be active in the sauna cabin
during these periods.
After tapping the input field, the font turns white and the navigation field is shown.
Set the values required and save the input.
Field No. : 2 different operating periods can be configured, e.g. No. 1 for ladies'
sauna in the morning and No. 2 for mixed sauna in the afternoon.
The time blocks must be at least 30 minutes apart!
This means the end of period
no. 1 must be at least 30 minutes before the start of period no. 2. For shorter
distance, the system reports an error while saving the settings. The error is shown
by the Start field with a red frame. Change the starting times accordingly, then
save again.
The Cycle column can be used to set the cycle length in minutes for 2 subsequent
splashes during this operating period. Save the result with OK .
The Pump column can be used to select the desired dosing pump and thus the
corresponding fragrance by tapping the field several times. 1 to 4 different dosing
pumps are available, depending on the version of the device.
The Number column can be used to set the number of splash repeats per cycle
by tapping this field several times.
Save the input with SAVE .
The device automatically changes between different fragrance pumps when the
Alternate function is activated. This function is only available when more than 1
fragrance pump is installed.
HINT !
The earliest Start time you can set is 00:01! The last cycle should be
started not later than 23:30! Otherwise, it may overlap with the
next day.