Tools Needed:
14
Tools Needed:
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
vertical Track
IMPORTANT:
ThE TOPs Of ThE
VERTICal TRaCks MusT bE lEVEl
fROM sIDE TO sIDE. If ThE bOTTOM
sECTION Was shIMMED TO lEVEl IT.
ThE VERTICal TRaCk ON ThE shIMMED
sIDE, MusT bE RaIsED ThE hEIGhT Of
ThE shIM.
Position the left hand vertical track
assembly over the rollers of the bottom
section. Make sure the counterbalance
cable is located between the rollers
and the door jamb. Drill 3/16” pilot
holes into the jambs for the lag
screws. loosely fasten jamb brackets
and flagangle to the jamb using
5/16” x 1-5/8” lag screws. Tighten lag
screw securing bottom jamb bracket to
jamb, to maintain 5/8” spacing. hang
cable drum over flagangle.
Repeat for the right hand side.
3/16” Drill bit
Power Drill
7/16” socket
Driver
Tape Measure
level
step ladder
11
bOTTOM sECTION
VERTICal TRaCk
ROllER
5/8”
15R qI flaGaNGlE
12R qI flaGaNGlE
12R & 15R fully
aDjusTablE flaGaNGlE
laG
sCREW
lOCaTIONs
laG
sCREW
lOCaTIONs
laG
sCREW
lOCaTIONs
laG
sCREW
quICk INsTall
jaMb bRaCkET
bottom Section
Center the bottom section in the door
opening. level section using wooden
shims (if necessary) under the bottom
section.
level
10
bOTTOM sECTION
WE
aTh
ER s
Eal
lEVEl
WOOD shIMs
(If NECEssaRy)
bOTTOM
sECTION
5/16” x
1-5/8” laG
sCREWs
flaGaNGlE
VERTICal
TRaCk
assEMbly
q.I. jaMb
bRaCkET
jbus
jaMb
bRaCkET
