15
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.wayne-dalton.com
Stacking Sections
Power Drill
7/16” socket
Driver
(2) 1/4”-14 x 5/8”
sElf TaPPING sCREWs
END hINGEs (lEfT haND shOWN, RIGhT
hINGE syMMETRICally OPPOsITE)
INTERMEDIaTE hINGEs
(3) 1/4”-14 x 5/8” sElf
TaPPING sCREWs
12
NOTE:
for door section identification see
page 4.
NOTE:
Make sure hinges are flipped down,
when stacking another section on top.
NOTE:
larger doors will use long shaft
rollers with double wide end hinges
Place rollers in hinge tubes of the second
section (lock section). With assistance, lift
second section and guide rollers into the
vertical tracks. keep patterns on front of
sections aligned, and fasten center hinges
first and end hinges last with 1/4”-14 x
5/8” self tapping screws. Repeat for other
section(s) except top section.
IMPORTANT:
Push & hOlD ThE hINGE
lEaf aGaINsT sECTION WhIlE sECuRING
WITh 1/4”-14 x 5/8” sElf TaPPING
sCREWs. END hINGEs haVE (2) sCREWs
aND INTERMEDIaTE hINGEs haVE (3)
sCREWs; DOublE END hINGEs haVE (5)
sCREWs.
NOTE:
lock(s) are required if door is not
installed with opener. Install lock at this
time (sold separately) see instructions in
OPTIONal INsTallaTION on page 32.
(5) 1/4”-14 x 5/8” sElf
TaPPING sCREWs
DOublE END hINGEs (lEfT haND shOWN,
RIGhT hINGE syMMETRICally OPPOsITE)
13
Top Roller Slides
To install the top roller slides, align
the slots in the top roller slide with the
second set of holes on the bottom of the
u-bar.
loosely, fasten using (2) 1/4” - 14 x 5/8”
self tapping screws. The bracket will be
tightened and adjusted in step 18. Insert
rollers into top roller slide. Repeat for
left side.
TOP ROllER slIDE
1sT
2ND
3RD
TOP RIGhT sIDE
(2) 1/4”- 14 x 5/8”
sElf TaPPING
sCREWs
ROllER
Power Drill
7/16” socket
Driver
step ladder
INST
All
ATION
