WaveReX WaveU, Руководство по эксплуатации

Страница: 24 / 30

First steps
page 24 of 30
Velocity Curves
0 5
1 6
2 7
3 8
4
Adding samples to a voice
A Tone is initially just an empty shell with no content, a few basic settings
and the Voice, which is also initially empty.
A voice is a multisample that can contain up to 12 individual samples.
Each Tone can consist of up to two Voices.
A multisample can be seen as a container, in which all samples with the
corresponding parameters are located. Multisamples are used to assign
each individual sample to a fixed zone on the keyboard (key zone).
To load samples into a voice you have two possibilities:
You can add a new, empty sample by clicking the plus button (+) below
the sample list. Then double-click on the new sample in the list. A dialog
window will open. Use the window to navigate to the folder where your
samples are located. Select the sample you want to add to your voice.
Double click on your selection or confirm by clicking OK.
The second way to add a sample is by drag and drop. Simply drag your
sample over the samples list and release it. The sample will be added to
your voice. Alternatively, you can drag multiple samples into the list at
once.
The name of the sample is taken from the file name without spaces or spe-
cial characters. Renaming the sample is not possible, because the Roland
format does not provide a sample name. Accordingly, no sample name
can be displayed by the device.
Setting a loop
The Loop active checkbox is activated by default and looping of the sam-
ple is therefore active. If you do not want a loop, deactivate the checkbox.
If the loop is deactivated, the sample will only be played from the start
point to the loop point!
If the loop is activated, the sample is played from the start point over the
loop point to the end and then the loop. How the loop is played depends
on the loop mode, which you can set in the dropdown field.