WaveReX WaveU, Руководство по эксплуатации

Страница: 23 / 30

First steps
page 23 of 30
General tone settings
Now you can make general settings for the tone. The general settings for
the respective tone can be found in the left window.
Please note that the parameters listed here are globally valid for the entire
tone.
You can change the name of your tone
via the text field Tone Name. The
length here is Roland-typical 8 charac-
ters.
Below that, you can specify the type
of tone using the Tone Type drop-
down field. If you have created a new
tone, Single is preset here. This
means that only Voice 1 is available.
Check this and click on the Voice 2 tab
in the Voice Editor and make sure that
all parameters for this voice are grayed
out. Now select Dual from the Tone Type drop-down box. Voice 2 should
now be activated. But let's start with a Single Tone for now, so set the
Tone Type back to Single.
The next two dropdown fields allow you to set a velocity curve for each of
the two voices separately. Here you can choose from 9 different curve
types. Please note that the curve for Voice 2 is only relevant if you have
selected a Tone Type that uses both voices, such as Dual.
The Velocity Threshold knob can be used to set the threshold for velocity,
such as for the Tone Type Velocity Switch.
Example: If this is set to 64 and it is a Velocity Switch type Tone, Voice 1
will play for all velocities up to 64 and Voice 2 will play for all velocities
above 64.
Tone Types
Single
– this is a Tone that consists exclusively of Voice 1. Accordingly,
the velocity curve can only be changed for Voice 1. The Velocity Threshold
parameter has no effect on a single tone.
Dual
– a tone consisting of both voices, which are played simultaneously.
However, a velocity curve can be specified separately for both voices. The
Velocity Threshold parameter has no effect on a Dual type tone.
Detune
– this is also a Tone that consists exclusively of Voice 1. However,
this is additionally detuned in the device. The velocity curve can only be
changed for Voice 1. The Velocity Threshold parameter has no effect on a
Detune type Tone.
veloMix (Velocity Mix)
– a tone consisting of both voices. For all velocities
below the set threshold Velocity Threshold, only Voice 1 is played. Above
the set threshold, Voice 2 is also played. A velocity curve can be specified
for both voices. The Velocity Thresh-old parameter thus controls when
Voice 2 starts.
veloSw (Velocity Switch)
– one tone, consisting of both voices. For all ve-
locities below the set threshold Velocity Threshold, only Voice 1 is played.
Above the set threshold, only Voice 2 is played. A velocity curve can be
specified for both voices. The Velocity Threshold parameter thus controls
when switching between Voice 1 and Voice 2 takes place.