The software editor
page 15 of 30
Loop settings
Here you can make all settings for the loop and the length of the currently
selected sample.
Activate the checkbox
Loop active
to activate the looping of the sample.
Use the checkbox below to select between the two loop modes forward
(
FW
) and backward (
BW
).
Use the arrow keys at the respective fields to set the offset, i.e. the start,
loop and end point of the sample in single steps. Activate the checkbox
snap at zeros
to adjust the step size of the arrow keys to the respective
distance of the zero crossings. The offset is thus set to the next zero
crossing of the sample. This can be helpful when searching for a suitable
loop.
Activate the checkbox
lock Loop
to keep the loop length when the loop
start or sample end is changed.
Pitch settings
The drop-down field allow you to set the
root note
for the currently se-
lected sample. This also serves as the top key for the key zone in which
the sample is played. This keyzone is limited downwards by the top key of
the keyzone below it, if present.
If the sample name contains the root note, this can be taken over via the
RootNote from Name
button.
The
PC
(Pitch Correction) knob can be used to adjust the pitch of the sam-
ple (positive only) and the
LP
(Loop Pitch) knob can be used to adjust the
pitch of the loop (positive and negative) in cent steps.
Best Practice:
To avoid the disadvantage that the pitch correction only works positively,
Roland likes to set the root note of the samples a semitone too low and
compensate the rest via the pitch correction.
Содержание WaveU
Страница 1: ......
