IMPORTANT:
Always maintain vigilance and follow all standard safety protocols around
water. Never rely solely on the LEA system.
AFTER USING YOUR LEA SYSTEM
1.
All Lifeguard Tags should be accounted for and returned for storage.
2.
Power down the Hub using Power Down Process.
3
.
If battery power is used, recharge the Hub.
5.
Clean and dry the Hub if required, wiping down with damp soft cloth*.
6
.
While cleaning occasionally inspect Hub and Tags for any signs of damage.
7.
Store the Hub in a dry location. Use the Wall Mount only if it is installed in a
protected area.
* Do not use ammonia based cleaning products as these may damage plastics over time.
TROUBLESHOOTING
System does not power on.
1.
Confirm that you followed the steps in POWERING AND CHARGING YOUR LEA Hub section.
2.
If the Hub determines that its batteries are too low it may automatically power down the system to protect the
batteries and electronics. Connect the AC Charging/Power Adapter to the Hub and plug the Charger into a wall
outlet. After approximately 30 minutes try powering on the Hub again. Check battery level and continue charging
unit the battery level is 100%.
System goes into Entry Alert with no active Lifeguard Tags.
1.
Scan the water immediately to confirm that there are no guards or Lifeguard Tags in the water.
2.
Restart the Hub following the steps in POWERING AND CHARGING YOUR LEA HUB section.
3.
If restarting the Hub does not solve the issue, move the Hub to a new location (see UNDERSTANDING WHERE
TO PLACE THE LEA HUB section).
WAVE LEA System User Guide v0922-1.0
Page of
22
24
