POWERING & CHARGING LEA
The LEA Hub may be powered via the internal battery
or the AC Charging/Power Adapter. The standard
battery will last up to
6 hours of typical use
*.
Fully charging the battery normally takes up to 4 hours.
After this initial set up process you may view the Hub’s
battery level at any time by using the LEA Management
App (see below).
Note: Always insert Connector Plug into Hub Power/
Charging Port first, then plug power cord into AC wall outlet.
START UP PROCESS
Press the Power Button to initiate the startup process. The LED on the Power Button will glow
green, the Strobe will light up in a “chase” pattern, and depending on your software version
installed, a tone may sound. Once the start up process is complete (typically up to 2 minutes),
the Strobe will begin a slow fade in/fade out “breathing” pattern to indicate that the Hub is on.
Note: If red light appears on Power Button during start up process, a restart is needed. Press
and hold Power Button for 10 seconds to initiate restart the Hub.
WAVE LEA System User Guide v0922-1.0
Page of
8
24
Power
Button
Strobe
Power/Charging Port
Power Cord
AC Charging/
Power Adapter
Connector Plug
